**Lid and Liner Not Included**Must be purchased seperately**
Series TRH Trash Receptacles are an attractive way to collect trash or recyclables while disguising and protecting the liner inside from abuse and vandalism.
Series TRH Trash Receptacles are available in three sizes:
Model TRH-20 (20-3/5" ID) holds a 20 - or 24-gallon capacity cab or liner
Model TRH-32 (22-3/8" ID) holds a 31- or 32- gallon capacity can or liner.
Model TRH-55 (25-3/8" ID) holds a 55-gallon barrel or liner.
**ASSEMBLY MAY BE REQUIRED**
FRAMES: TRH Series frames include a top and bottom ring; both rolled using 10 ga. steel with a formed flange for strength. The base ring is reinforced with die-formed cross braces. These braces also serve to keep the container inside the TRH up off the ground. Galvanized fasteners included. The base frames include (3 or 4) 9/32" dia. holes in flange to allow anchoring to a concrete surface with appropriate anchors. (Anchor bolts are not included-use 1/4" x 2-1/4" concrete screws).
FRAME FINISH: Standard finish: Hot dip galvanized after fabrication for maximum protection. Or choose power coated (in place of galvanized finish) in your choice of color.
MATERIALS: 2"x 4" (nominal) slat material: OR 100% recycled plastic slats available in choice of colors.
OPTIONAL: A variety of steel and plastic dome and flat lids are available for this receptacle to collect trash and recyclables. These lids are not made of Recyled Plastic.
OPTIONAL: Stationary mounts are available.
OPTIONAL: Galvanized steel cans or rigid plastic liners are available.
OPTIONAL: Custom engraving is available on recycled plastic slats.
Estimated Lead time prior to shipment: 2-4 weeks
100% Recycled Plastic
Timbers, planks, and frames
This recycled plastic material is 100% recycled high-density polyethylene and is formed using a combination of post-consumer and post-industrial waste plastics. There is no virgin plastic in this product. Post-consumer plastic has been used by a consumer and then recycled to avoid dumping in a landfill (such as milk jugs). Post-industrial plastics have gone through a manufacturing process but never reached the consumer (such as product rejects or process wastes). On average our product is 80% post consumer and 20% post industrial (percentages can vary). Our plastic components are 100% recycled and can also be recycled again and again. There are no toxic chemicals in this product. Plastic by its very nature does not leach.
A solid color is formed throughout the component and a UV stabilizer is added for ultraviolet protection. This recycled plastic is a dense, durable product, offering a long lasting, attractive appearance. It will not splinter or rot, and is resistant to mold and insects. These components are molded into solid dimensional shapes corresponding to nominal lumber dimensions. Recycled plastic components are available in your choice of colors.